Reads high-side and low-side refrigerant pressures to calculate superheat and subcooling. Tells us whether the charge is correct or there's a leak.
Residential AC Repair in greenville that gets your cool back
When your house stops cooling in the middle of a Texas summer, you need Residential AC Repair in greenville that shows up fast and fixes it right. We handle home AC Repair Greenville TX for every major brand, from Carrier and Trane to Goodman and Rheem.
Serving greenville and nearby areas.
How big is the job?
Component repair
Fan motor, drain line, or refrigerant leak. Longer diagnostic, sometimes a second visit.
- 1. Part swap Capacitor, contactor, or thermostat replacement. One visit, common parts on the truck.
- 2. Component repair Fan motor, drain line, or refrigerant leak. Longer diagnostic, sometimes a second visit.
- 3. System-level Compressor or coil work. Planned in writing first with options laid out.
Drag the needle to compareTouch and drag the needle
- 27Services from one local team
- 20Areas served around greenville
- Test firstWe measure before we replace
- ExplainYou see the failed part
What's included in a Residential AC Repair visit
Every repair call includes a full diagnostic, a written finding on each component we test, and a flat-rate quote before we start.

Work order
Residential AC Repair- Full system diagnostic: Thermostat, air filter, blower amp draw, capacitor microfarads, contactor points, refrigerant pressures, and temperature split. Takes 45-60 minutes. You get a written finding on each item, good or bad.
- Flat-rate repair quote: We show you the failed part, explain what it does, and give you the installed price before we start. No hourly billing, no after-the-fact add-ons. You approve the number or we pack up.
- Parts and labor: Capacitors, contactors, fan motors, thermostats, and common relays ride on every truck. Refrigerant repairs include recovery, vacuum, and recharge with R-410A or R-32 to manufacturer spec.
- System test and verification: We run the system 15-20 minutes, verify 16-22 degree temperature split, check for condensate leaks, and confirm the thermostat holds setpoint. If it doesn't test right, we don't call it done.
- Workmanship warranty
What the first visit covers
First visit
We test the thermostat, capacitor, contactor, blower, and refrigerant pressures, then tell you what failed and what it costs to fix.
Residential AC Repair at your home
We work on the systems homeowners actually have, from older ranches to newer two-story builds.
No cool air
Warm vents, weak airflow, or a system that won't start.
Water leaks
Clogged drain lines and overflowing pans.
Short cycling
System turns on and off without finishing a cycle.
Strange noises
Grinding, squealing, or rattling from the unit.

Residential AC Repair at business properties
Small commercial spaces use the same split-system components, just scaled up.
Small offices
Split systems up to 5 tons.
Retail spaces
Rooftop and packaged units.
Rental properties
Turnover repairs and tenant calls.
What Residential AC Repair in greenville really involves
A failed capacitor costs a couple hundred dollars to fix. A failed compressor costs a couple thousand. Testing the small parts before they take out the big ones is the whole job.
Residential AC Repair in greenville is the diagnostic and mechanical work that restores cooling to a home's air conditioning system, whether that means replacing a failed capacitor, clearing a clogged drain line, or tracking down a refrigerant leak with an electronic leak detector. It covers the full range of residential HVAC repair Greenville TX homeowners deal with: AC not cooling, AC short cycling, frozen evaporator coils, and compressors that won't kick on. We test the whole system, not just the part that quit.
In Hunt County, summer heat pushes equipment hard from May through September, and October is when we start seeing the damage: weak capacitors, worn contactors, and drain lines full of algae. If your home AC not cooling repair Greenville Texas call comes in now, we can often catch a failing part before it takes the compressor with it.

- What it is
- Diagnostic and repair work on a home's cooling system.
- When it helps
- When the house won't cool, leaks, or won't turn on.
- What you get
- A written finding, a flat quote, and a tested repair.
How our repair process works
Five steps, start to finish. You'll know what's wrong, what it costs, and when it'll be fixed before we pick up a wrench.
Tools and methods we use
Each method answers a different question. Together they leave very little to guess.
Pulls a deep vacuum on the line set after a repair. Removes moisture and non-condensables so the new charge stays clean.
Recovers R-410A or R-32 before opening the system. Required by EPA Section 608 rules and keeps refrigerant out of the atmosphere.
Measures amp draw on the compressor, condenser fan, and blower motor. High or low amps point to a failing motor or a bad capacitor.
Sniffs brazed joints, coils, and line sets for refrigerant leaks. Finds leaks that pressure testing alone can miss.
When greenville homeowners call us
It's 8 p.m. in August, the AC quits, and the house is already 84 degrees. Kids are trying to sleep.
We take the call, ask a few diagnostic questions, and dispatch a technician if we have a slot.
HomesYour system is 12 years old, running but not cooling well, and you're wondering whether to repair or replace.
We run a full diagnostic, check compressor amp draw and refrigerant pressures, and give you both numbers: the repair cost and a…
HomesYou're selling a house in Berea and the buyer's inspector flagged the AC as not cooling properly.
We do a diagnostic, document what we find with photos and pressure readings, and repair what's needed.
HomesYour AC has been making a grinding noise for a week and now it won't turn on at all.
Grinding usually means a fan motor or compressor bearing.
Homes
How Residential AC Repair runs in greenville
greenville sits in Hunt County, where summer highs push 100 degrees and humidity stays high enough that drain lines clog fast. Most homes here run central split systems, and we see a lot of 1990s and 2000s builds with original ductwork that's undersized for the tonnage.
Downtown Greenville
Older homes with pier-and-beam construction and retrofitted ductwork. Return air sizing is often the hidden cause of frozen coils.
Tanglewood
Newer two-story builds with upstairs units that work harder. We see more compressor and condenser fan motor failures here.
Sterling
Mix of 1970s ranches and newer construction. Older systems still running R-22 need a different repair approach than R-410A equipment.

- Downtown Greenville
- Tanglewood
- Sterling
- Berea
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoFailed capacitor to cold air in 45 minutes
Before: A homeowner in Downtown Greenville called at 1 p.m. in July. The condenser was humming but the fan wasn't spinning, and the house was at 86 degrees. The capacitor read 12 microfarads against a 35-microfarad rating.
After: We replaced the dual-run capacitor with a matching 35/5 MFD unit, tested amp draw at 14.2 amps (within spec), and verified a 19-degree temperature split. The house hit 74 degrees by 3 p.m.
Refrigerant leak repair saves a 12-year-old system
Before: A Tanglewood homeowner had added refrigerant twice in two summers. The system was cooling poorly and the compressor was running hot. Pressures showed low suction and high superheat, confirming a leak.
After: We found a leaking Schrader valve and a pinhole in the line set with an electronic leak detector. Repaired both, pulled a 500-micron vacuum, and recharged with R-410A to factory charge. Temperature split came back to 20 degrees.
Clogged drain line cleared before ceiling damage
Before: A homeowner in Sterling noticed water staining on the ceiling below the air handler. The drain pan was full and the float switch had tripped, shutting the system down. The drain line was clogged with algae and debris.
After: We cleared the clog with compressed nitrogen, flushed the line with hot water, and verified full drainage. The float switch reset and the system ran a full cycle without tripping. No ceiling repair needed.
Common AC problems we fix in greenville
Most residential AC Repair near me Greenville TX calls fall into a handful of categories. Here's what we see and how we handle it.
AC not cooling, warm air from vents
The house climbs past 80 degrees by afternoon, and running the system in this state can damage the compressor.
AC leaking water inside the house
Water on the floor or ceiling stains.
AC short cycling, turning on and off
Short cycles wear out the compressor and run up your electric bill.
AC frozen evaporator coil
Ice blocks airflow and the system stops cooling entirely. Running it frozen can send liquid refrigerant back to the compressor and kill it.
Why homeowners call us first
We keep residential air conditioning service Greenville Texas simple: find the fault, fix it, test it, and show you what we found. No upsells, no guesswork.
Same-day service
Most residential AC Repair near me Greenville TX calls get a technician at the door the same day.
Flat-rate pricing
You get the price before we start. No hourly surprises, no after-the-fact add-ons. We quote the job, you approve it, we do the work.
All major brands
Carrier, Trane, Lennox, Goodman, Rheem, York, American Standard, Bryant, Mitsubishi Electric, Daikin, and LG.
Repairs that hold
We test refrigerant pressures with a manifold gauge set, check amp draw with a clamp meter, and verify temperature split before we leave.
What Residential AC Repair costs in greenville
Capacitor and contactor replacements sit at the low end. Blower motors, refrigerant leak repairs, and compressor work run higher.
Included
Quoted after a first look
- Full system diagnostic
- Flat-rate repair quote
- Parts and labor
- System test and verification
What changes the scope
Quoted after a first look
- Failed component type
- Refrigerant type and charge
- System age and accessibility
- Leak repair complexity
What you get on a repair job
Clear records you can keep and share.
Written findings
Each component tested, good or bad.
Flat-rate quote
Installed price before we start.
Test results
Temperature split and amp draw readings.
Local experience you can lean on
Every truck carries a manifold gauge set, vacuum pump, recovery machine, multimeter, clamp meter, leak detector, fin comb, tube cutter, flaring tool, swaging tool, thermometer, and…

Capacitor microfarads
Read with a multimeter and compared to the rating on the label. More than 10% low means replace.
Compressor amp draw
Read with a clamp meter and compared to the nameplate RLA. High amps mean a failing compressor.
Temperature split
Supply air versus return air. A 16-22 degree difference means the system is cooling properly.
Do we cover your part of greenville?
Type your ZIP or town to check. If it is not listed, call and ask.
greenville ZIP codes
- 75401
- 75402
Towns we serve.
Based in greenville and covering the places around it. Pick one for local details.
What greenville homeowners say
Our AC quit on a Saturday in July. Greenville CoolCraft had a tech at the house by 2 p.m. Turned out to be a failed dual-run capacitor. He had the part on the truck, swapped it in 30 minutes, and the house was cool by 4. Charged exactly what he quoted. No games.
We'd had two other companies out for the same problem, AC running but not cooling. Greenville CoolCraft found a refrigerant leak at a brazed joint the others missed. Repaired it, pulled a vacuum, recharged, and the temperature split was 20 degrees when they left. That was two summers ago and it's still holding.
Our 1998 Trane was short cycling and we figured we needed a new system. Honest diagnosis saved us thousands. We've used them for tune-ups ever since.
Frequently Asked Questions
Short answers for the first few minutes. The team can cover the rest.
Describe what you are seeing and we will point you to the right next step.
(903( 304-5500Capacitor and contactor replacements sit at the low end. Blower motor, refrigerant leak, and compressor repairs run higher. Typical 2026 pricing in this area reflects parts cost and job complexity, not hourly billing. We quote the full job before we start, so you know the number up front.
Twice a year, once in spring before the cooling season and once in fall. In Hunt County, we recommend the spring tune-up as the critical one because your system runs May through September without a break. A tune-up includes filter check, coil cleaning, capacitor testing, drain line flush, and refrigerant pressure check.
The most common causes are a failed capacitor, a clogged air filter, low refrigerant from a leak, or a frozen evaporator coil. In greenville's humidity, drain line clogs also cause shutdowns when the float switch trips. We diagnose all of these in one visit with a multimeter, clamp meter, and manifold gauge set. Most of the time it's a single failed part, not a dead system.
Greenville CoolCraft does, and we cover all of greenville and Hunt County, including ZIP codes 75401 and 75402. We handle home AC Repair Greenville TX for every major brand and offer same-day service on most calls. Call (903) 304-5500 and we'll get a technician to your door, usually within a few hours.
Get Residential AC Repair in greenville today
(903( 304-5500Your house won't cool itself. Call (903) 304-5500 and we'll get a technician to your door, usually the same day.
Get in touch with our crew
Call (903) 304-5500 and you will talk to someone who knows cooling, not a call center script. We answer weekdays from 8 a.m. to 6 p.m. If you are in ZIP 75401 or 75402, we are usually nearby.







